July 04, 2015
The correct use and maintenance will maximize the performance of air
conditioning and extend the service life, and the error use will
greatly damage the air conditioning systems, to make life greatly
reduced. Automobile Air Conditioning life depends largely on whether the
user is able to correctly use and maintenance. You can use the Auto Diagnostic Tool to check car air conditioning performance, air conditioning installed
on the car must be carefully read the use of instructions, in accordance
with the above instructions.

1, In order to avoid the excessive load of the engine starting, while
the air conditioning compressor can quickly into the best working
conditions, the first not to rush to the open air. Should put doors,
windows open, you can use a fan for ventilation, etc. twenty or three
minutes later to sit in the hot gas discharge start the car, and do not
rush to close the windows, turn on air-conditioning outside the circle,
when the inside and outside the temperature is close, and then close the
window, enabling the internal cycle.
2. Select the appropriate
air temperature, air conditioning maintenance is the first step. Because
of the hot weather, many owners prefer to adjust the temperature too
low, which will affect their health. Under normal circumstances, the
compartment temperature difference with the outside temperature should
be 5 ℃ to 6 ℃, the optimum temperature of air conditioning is 18 ℃ to 25
℃.

3, Refrigeration and air conditioning wind best blowing up, because the
cold air to the sink, the direction of the wind tests are best choice
blow face gear, adjust the outlet up effect is best, don't choose the
windshield of the block, because the temperature of the windshield is
very high, would offset a large refrigeration effect. When selecting
wind speed gears don't always use top gear, big air volume refrigeration
effect is not good. If only the front occupants to choose 2 or 3 block
wind speed is enough.
4, suggested that the owners to best in
preparation for parking in front of the 6-7 minutes will close the air,
let the remaining heat from the evaporation tank water drying, eliminate
and outside temperature, so that you can easily keep air conditioning
system relatively dry, can reduce air conditioning odor. Moreover, in
front of the parking lot to close the air conditioning, will avoid the
impact of the battery and air conditioning, to prevent damage to the
engine.

Automotive air conditioning system in use process, the air will flow in
the blower, refrigerating system evaporation tank, heating system of
the small water tank and the air duct. As long as the air conditioning
system blower or the air intake mode choice in the indoor cycle,
regardless of whether the use of refrigeration devices, air will enter
the system. Through Launch X-431 PAD or Launch X431 GDS tool to check show that the above device surface accumulation with a
lot of dust, moisture, bacteria and other dirt, and will cause damage
and allergic reactions to human respiratory system and skin, directly
affect the occupant's health, and air-conditioning system itself will
appear refrigeration effect is bad and a small amount of wind and other
fault.

Under normal circumstances every 5,000 km or 3 months to conduct a clean air filter, every 20,000 km or 12 months use Xtool PS2 or Autoboss V30 SPX tool to check the air conditioning, and replace the air filter. This
will ensure that you can enjoy the fresh clean car interior environment
to ensure your health.
Source: http://www.focalobd.com/blog/how-to-correctly-use-car-air-conditioning/
Posted by: obdtools at
03:48 AM
| No Comments
| Add Comment
Post contains 597 words, total size 7 kb.
35 queries taking 0.0302 seconds, 57 records returned.
Powered by Minx 1.1.6c-pink.








